Popular Post

Showing posts with label bourden tube. Show all posts

Fluid Mechanics Lab

By : Asad Ali Arshad
Bourden tube experiment
Bourden Tube Experiment









1. Dead Weight Calibrator.pptx

null

To Calibrate a Bourdon Type Pressure Gauge Using a Dead Weight Pressure Gauge Calibrator

Theoretical Background
1. Calibration: To check error with comparison to some standard device is called calibration.
2. Absolute Pressure (Pabs): The pressure that is taken with reference to absolute zero is called absolute pressure, and at absolute zero there is a perfect vacuum.
3. Gauge Pressure (Pg): The pressure that is taken with reference to atmospheric pressure is called gauge pressure. It may be positive or negative depending upon whether we take (Pg) above the atmospheric pressure or below the atmospheric pressure. Gauge pressure is always measured with atmospheric pressure, that is why when gauge pressure is at atmospheric pressure it results zero.
Pabs = Patm + Pgau


Bourdon Tube Pressure Gauge:
uThe bourdon tube pressure gauge is the most common type used to measure fluid pressure because it is reliable, inexpensive and relatively simple.
uThe bourdon tube is a curved tube closed at one end, which is attached to a spring-loaded mechanism that is itself attached to the gauge’s needle.
uThe port of the gauge is attached to the location in the system where you’re measuring pressure.
As pressure increases within the bourdon tube, the metal tube starts to straighten, and as it does, it tugs on the lever attached to the needle.
Apparatus: Dead Weight Tester
Procedure:
1. Remove the piston from unit.
2. Close valve V1 and open valve V2.
3. Fill cylinder with oil.
4. Now close valve V2.
5. Put piston back in position with V1 and V2 in close position.
6. Read out pressure value on gauge and compare it with theoretical results.
7. Repeat the experiment by adding weights.

Hitec Mechanical Engineering

Mechanical Engineeirng Hitec Mechanical Engineering As we know Mechanical Engineering is the branch of engineering dealing with the des...

- Copyright © Hitec Mechanical Engineers - Hitec Mechanical Engineer - Powered by Blogger - Designed by Asad Ali Arshad -